Pine wood Powerbank
Pine wood Powerbank
The Process
The Process
- Chiseling the Pine
A piece of pine wood was chiseled to form an extruded 'U'-shape. Tools used were a c-clamp, a chisel and a hammer.
2. Circuit and plywood
2. Circuit and plywood
The powerbank charging board was installed and screwed. A plywood piece was glued to the side using PVA to close the box. Holes were chiseled to fit 2 USB ports and a micro USB port.
3. Batteries and closing the box
3. Batteries and closing the box
Six 18650 lithium-ion cells were inserted into the powerbank. The top was then closed using a sheet of polyethylene plastic, glued using cyanoacrylate glue. Some linseed oil was applied to give a light finish.
Bottom view
Bottom view
Top view
Top view